Types of gravel: which stone goes where

Walk into a stone yard and you will see a dozen piles with names that change from one supplier to the next. The names matter less than two simple questions: is the stone crushed or round, and is it clean or mixed with fines? Answer those and you can pick the right material for almost any outdoor project.

The two questions that decide everything

Crushed or round?

Crushed stone has been broken in a crusher, so every piece has sharp, flat faces. Under pressure those faces wedge against each other and the layer locks together. That is what you want under anything that carries weight.

Round stone (river rock, pea gravel) has been smoothed by water. It feels nice underfoot and drains well, but the pieces roll over each other. It shifts under tires and never firms up into a solid base.

Clean or with fines?

Clean stone has been screened so the dust and small particles are removed. The gaps between stones stay open, so water drains straight through. It is easy to work and drains very well, but it does not bind into a hard crust on its own.

Stone with fines keeps the dust. When it is dampened and compacted, the fines fill the gaps and the layer sets almost like a weak concrete. It sheds water off the top instead of letting it through. This is the material that makes a firm driving or walking surface.

The four combinations and what they are good for
Clean (no fines)With fines
CrushedDrainage layers, driveway middle layer, under pavers in permeable builds, around fence postsDriveway and path surfaces, paver and patio base, compacted pads for sheds
RoundDecorative beds, play areas, drainage trenchesRare; not used structurally

Common gravel types explained

The names below are widely used in the US. Your local supplier may use different names or numbers, so always confirm the size range and whether it contains fines.

Crusher run / dense-graded aggregate / "¾ minus"

Crushed stone from roughly ¾ in down to dust. Compacts into a very firm, stable layer. This is the default top layer for a gravel driveway and the most common base under pavers and patios. Sometimes called road base, quarry process, QP, or by a local DOT spec number.

#57 stone (¾–1 in clean crushed)

One of the most common clean crushed sizes. Drains freely and locks reasonably well. Used as a driveway middle layer, for drainage behind retaining walls, in the bottom of post holes, and under permeable pavers. On its own as a driveway top it stays loose.

Large crushed stone (#3, #2, 1½–3 in)

Big angular stone for the bottom of a driveway build, construction entrances and soft ground. Too coarse to walk or drive on directly.

Pea gravel

Small, rounded stone about ⅜ in. Comfortable underfoot and attractive in garden paths, patios with edging and play areas. Not suitable as a driveway surface or as a base under pavers, because it rolls and never compacts. If you use it on a path, contain it with solid edging and expect to rake it back into place.

Decomposed granite (DG)

Granite weathered into small particles and fines. When compacted it forms a natural-looking, firm path surface. Stabilized DG includes a binder to reduce erosion. Good for paths and patios in dry climates; can get soft and track indoors in wet ones.

Stone dust / screenings

The fine material left after screening crushed stone. Sometimes used as a thin leveling layer under pavers or flagstone. It holds water, so many paver manufacturers now prefer coarse concrete sand or a fine clean chip for the bedding layer instead. Check the installation guide for your pavers.

River rock

Large rounded stone, mostly decorative: dry creek beds, borders, around downspouts. Not for walking or driving surfaces.

Which gravel for which project

Quick reference
ProjectTypical choiceAvoid
Driveway base layerLarge crushed stoneRound stone
Driveway surfaceCrusher run / dense-graded with finesPea gravel, clean stone on its own
Paver patio baseDense-graded crushed base, or clean ¾ in for permeable buildsPea gravel, sand-only base
Garden pathDecomposed granite, small crushed with fines, or pea gravel with edgingLarge stone
Bottom of fence post holesClean crushed stoneFines that hold water
Drainage trenchClean crushed or round stone, wrapped in fabricAnything with fines

Weight and density: why it matters when ordering

Suppliers sell by the cubic yard, by the ton, or both. The link between the two is the density of the stone, which depends on rock type, size and moisture. Many crushed products fall roughly between 1.3 and 1.5 US tons per cubic yard, but the only figure that matters is the one your supplier uses. Ask for it, and enter it in the gravel driveway calculator so your volume and weight match their invoice.

For more on converting between the two, read cubic yards vs. tons: how to order gravel.

Color, size and looks

Color comes from the parent rock: limestone tends to grey and white, granite to grey, pink and speckled, trap rock to dark grey. Colored decorative stone usually costs more and may not compact as well as plain crushed stone, so a common approach is a structural base of local crushed stone with a thinner decorative top layer.

Frequently asked questions

What is the best gravel for a driveway?

There is no single best stone. A durable driveway uses large crushed stone at the bottom, medium clean crushed stone in the middle, and crushed stone with fines on top. See how deep a gravel driveway should be for typical thicknesses.

Can I use pea gravel for a driveway?

It is not recommended as a surface. Pea gravel is round, so it rolls under tires, ruts easily and spreads into the lawn. Some people use it in a stabilizing grid, which holds the stones in cells.

Is limestone or granite better?

Both work. Granite is usually harder and wears more slowly; limestone is common and economical in many areas. Local availability often decides, because trucking is a large part of the cost.

Sources and further reading

The ranges in this guide summarize published guidance like the sources above. Always follow the instructions for your specific product and any local rules.

Related