A fence is only as straight as its posts, and posts lean for three reasons: the hole was too shallow, frost pushed it up, or water rotted it at ground level. Getting the hole right takes care of all three. This guide covers depth, width, the frost line and what goes in the bottom of the hole.
Short answer
- Depth: a common rule is to bury one third to one half of the post's above-ground height, and at least below the local frost depth in cold climates.
- Width: a hole about three times the post width (10–12 in for a 4×4, about 18 in for a 6×6).
- Bottom: 3–6 in of tamped crushed stone for drainage.
- Local rules first: your building department may set minimum depths, especially for tall fences and gates.
How deep?
The traditional guidance is to bury a third to a half of the post's exposed height. A 6 ft privacy fence, with 6 ft of post above ground, would then need 2–3 ft in the ground. Taller fences, gates and fences in windy, exposed spots sit at the deeper end, because a solid fence panel acts like a sail.
| Fence height above ground | Typical hole depth |
|---|---|
| 3–4 ft (picket, garden) | About 18–24 in |
| 5 ft | About 24–30 in |
| 6 ft (privacy) | About 24–36 in |
| 8 ft | About 36–48 in |
| Gate posts | Deeper and wider than line posts |
Then check the frost depth.
The frost line
In cold climates the ground freezes to a certain depth each winter. Wet soil expands as it freezes and can grip the post and lift it, a process called frost heave. Posts that stop above the frost line can rise a little every winter and end up leaning or uneven.
Frost depth varies enormously, from almost nothing in warm regions to several feet in the far north. Your local building department can tell you the design frost depth for your area. A common recommendation is to set the bottom of the hole below it. A slightly bell-shaped hole, wider at the bottom than the top, also helps resist lifting.
How wide?
A hole about three times the post width gives enough concrete or packed gravel around the post to hold it firmly:
- 4×4 post (actual 3½ in): 10–12 in diameter
- 6×6 post (actual 5½ in): about 16–18 in
- Round metal posts (for chain link): commonly 8–12 in depending on post size; follow the fence maker's spec
A wider hole is not always better: it uses more concrete without making the post much stronger. A hole that is too narrow leaves a thin, weak collar that can crack.
Gravel at the bottom
Most fence builders put 3–6 in of crushed stone in the bottom and tamp it before setting the post. It gives the post a firm footing and lets water drain away from the end grain of a wood post instead of sitting in a concrete cup. Use clean crushed stone (for example ¾ in), not fines that hold water.
Concrete, gravel or soil?
Concrete
The most common choice for wood and metal posts. Very rigid. Finish the top slightly above ground and slope it away from the post so rain runs off rather than collecting against the wood.
Packed gravel
Some builders set wood posts in tamped crushed stone instead of concrete. It drains well, which can help wood last longer, and a damaged post is easier to replace. It is usually less rigid than concrete, so it suits lower fences and sheltered sites better than tall solid privacy fences.
Tamped soil
Workable for light farm and garden fences in firm soil, but posts are more likely to loosen.
Wood post tips
- Use posts rated for ground contact. Ordinary treated lumber is not always rated for burial.
- If you cut a treated post, treat the cut end as the manufacturer recommends.
- The weak point of a wood post is usually right at ground level, where it stays wet. Good drainage and a sloped concrete top help.
Before you dig
- Contact your local utility-locating service (811 in the US) several days before digging.
- Confirm your property line and any permit or height rules.
- Check whether your HOA or town has a rule about which side of the fence faces out.
Frequently asked questions
How deep for a 6 ft privacy fence?
Commonly 2–3 ft, and at least below your local frost depth. Gate posts and corner posts often go deeper.
Can I use a post hole digger for 36 in holes?
Yes, manually, though it is hard work in clay or rocky ground. A rented power auger saves time on long fences.
Count posts and concrete bags for your fence with the fence post concrete calculator. For the bag math, see how many bags of concrete per fence post.
Sources and further reading
The ranges in this guide summarize published guidance like the sources above. Always follow the instructions for your specific product and any local rules.